Arduino 101: with on-board motion sensors and Bluetooth LE radio. Explore the endless capabilities of physical computing. 13,162 views 2 comments 16 respects Toolbox 7. Project tutorial by TATCO.
![]() Arduino Emulator Download And Installpress and release NRST (reset) button to power cycle the processorStart the STM32CubeProg. It will look like this:Connect STM32 Blue Pill to ST-Link compatible Emulator And Programmer dongleFollow the wiring diagram below to connect the STM32 Blue Pill to ST-Link compatible Emulator And Programmer dongle.NOTE: Do not connect STM32 Blue Pill to computer via Type-C USB cable.Set the STM32 Blue Pill to bootloader mode using both BOOT0 and NRST button: STM32 Emulator And Programmer Dongle (Windows only)NOTE: Using JLink / ST-Link dongle to program the board will erase the Arduino bootloader.Download and install STM32CubeProg from ST.com:Start the STM32CubeProg. For Windows, you can check the assigned COM port in Device Manager.Create new sketch and copy / paste the code below:// initialize digital pin PB2 as an output.PinMode(PB2, OUTPUT) // LED connect to pin PB2DigitalWrite(PB2, HIGH) // turn the LED on (HIGH is the voltage level)DigitalWrite(PB2, LOW) // turn the LED off by making the voltage LOWClick on the upload button to compile and upload the code to STM32 Blue Pill.You should see the blue LED blink at 0.1 second interval.2. Vhs converter for mac to mp4Setup Arduino IDEBootloader mode using both BOOT0 and NRST button. Install STM32CubeProgFollow the wiring digram below to connect the STM32 Blue Pill toNOTE: Do not connect STM32 Blue Pill to computer via Type-C cable. USB to 3.3V TTL adapter (Windows only)NOTE: Using USB to 3.3V TTL adapter to program the board will erase the Arduino bootloader. The uploading speed of using ST_Link dongle is significantly faster than the Arduino bootloader.Once the sketch is successfully uploaded, the blue LED should blink at 0.1 second interval.3.
0 Comments
Leave a Reply. |
AuthorCory ArchivesCategories |